17
z
PVC: System provides 8 PVCs. Generally you can leave
this set at the default value 0. This option is also used to
create and configure new PVCs.
z
VPI: If you need any modification, please enter the VPI
value provided by ISP. See the attached table for all the
VPI default value of PVC.
z
VCI: If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default value of PVC.
z
Operation Mode: This also should be left at the default
setting Enabled. This enables the PVC used for the initial
connection.
z
Encapsulation: You can select the mode LLC or VC MUX.
z
Address Type: The bridged connection modes include
Pure Bridge, Static IP and DHCP.
I.
Pure Bridge
The setting page displayed as below will appear while you
chose Pure Bridge mode. The gray items don’t need configuration.
To Next Page
Loading...
