Huawei SmartAX MT800 - 5.4 RFC 2684 Bridged (Pure Bridge) Configuration

83
5.4 RFC 2684 Bridged (Pure Bridge)
Configuration
Configurations on MT800
Location Parameters Comments
PVC Select any one from the eight PVCs.
VPI/VCI The value shall be provided by your ISP.
Operation Mode Select “Enable”.
Encapsulation
The value shall be provided by your ISP.
Usually you can keep the default value:
LLC.
Connection Type Select “RFC2684 Bridged”.
ATM Setting
Address Type Select “Pure Bridge”.
Traffic Index It is recommended to set 0.
Configurations on the user’s PC
PPPoE Dial–up
Application
Before connecting to the Internet, the user shall have PPPoE
dial–up application installed on the PC.
5.5 RFC 2684 Bridged (Static IP) Configuration
Configurations on MT800
Location Parameters Comments
PVC Select any one from the eight PVCs.
VPI/VCI The value shall be provided by your ISP.
ATM Setting
Operation Mode Select “Enable”.