86
5.7 RFC 2684 Route (IPoA) Configuration
Configurations on MT800
Location Parameters Comments
PVC Select any one from the eight PVCs.
VPI/VCI The value shall be provided by your ISP.
Operation Mode Select “Enable”.
Encapsulation
The value shall be provided by your ISP.
Usually you can keep the default value:
LLC.
Connection Type Select “RFC2684 Routed (IPoA)”.
IP Address and
Subnet Mast
The values shall be provided by your ISP.
Default Route Select “Enable”.
ATM Setting
Gateway IP
Address
The value shall be provided by your ISP.
NAT It is recommended to enable the function of NAT.
DNS
It is recommended to have DNS Relay function enabled.
And set DNS IP address provided by your ISP.
DHCP Mode It is recommended to have DHCP Server function enabled.
Traffic Index It is recommended to set 0.
Configurations on the user’s PC
IP Address and
network mask
It is recommended to set the mode as obtaining an IP address
automatically.
DNS
It is recommended to set the mode as obtaining a DNS server’s
IP address automatically.
To Next Page
Loading...
