Huawei SmartAX MT800 - PPP Configuration

24
z
VCI: If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default values of PVCs.
z
Operation Mode: This also should be left at the default
setting Enabled. This enables the PVC used for the initial
connection.
z
Encapsulation: You can select the mode LLC or VC MUX.
z
IP Address and Subnet Mask: Enter the IP address and
subnet mask provided by ISP for the WAN interface of your
MT800.
z
Default Route: This setting specified the IP address below
is using for default route of LAN. The data will be sent
through WAN interface whenever a client LAN computer
accesses the Internet.
z
Gateway IP address: Enter the Gateway address
provided by ISP.
z
Traffic Index: Select the index number for ATM traffic from
the pull-down menu.
z
Configured MTU: Enter the maximum bytes of the packet
being transmitted during connection.
III.
Save
z
Click the Submit button to save the settings in the RAM.
z
To save these configuration changes permanently, enter
the Save & Reboot page, select Save and click Submit
button to save new settings.
4.3.3 PPP Configuration
There are two options for PPP configuration: PPPoA and
PPPoE.