26
z
VCI: If you need any modification, please enter the VCI
value provided by ISP. See the attached table for all the
VCI default value of PVC.
z
Operation Mode: This also should be left at the default
setting Enabled. This enables the PVC used for the initial
connection.
z
Encapsulation: You can select the mode LLC or VC MUX.
z
Connection Type: The bridged connection modes include
Pure Bridge, Static IP and DHCP.
z
PPPoA / PPPoE: Select PPPoA.
z
IP Unnumber: You can select enable or disable. When
Enabled is selected, the Ethernet port address will be used
as your IP address.
z
Traffic Index: Select the index number for ATM traffic from
the pull-down menu.
z
Configured MTU: Enter the maximum bytes of the packet
being transmitted during connection.
To Next Page
Loading...
