Figure 4-19 Installing an antitheft lock
----End
4.4 Support-mounting the SUN2000
4.4.1 Determining the Installation Position
Determine an appropriate position for installing the SUN2000.
Basic Requirements
The SUN2000 is protected to IP65 and can be installed indoors or outdoors.
The installation method and position must be appropriate for the weight and dimensions
of the SUN2000. For details, see 10 Technical Specifications.
Do not install the SUN2000 in a place where personnel are likely to come into contact
with its enclosure and heat sinks because these parts are extremely hot during operation.
Do not install the SUN2000 in an area that stores flammable or explosive materials.
Installation Environment Requirements
The ambient temperature must be below 50°C which ensures optimal SUN2000
operation and extends the SUN2000's service life.
The SUN2000 must be installed in a well ventilated environment to ensure good heat
dissipation.
The SUN2000 should be free from direct exposure to sunlight, rain, and snow to extend
its service life. Based on the actual installation environment, the customer can determine
whether to build an awning. Figure 4-20 describes the requirements for building an
awning (if required).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
