Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-18 Installing DC input power cables
After the positive and negative connectors are in position, the clearance between the DC
terminals and connectors should be less than or equal to 0.8 mm and the DC input cables
cannot be pulled out.
----End
Follow-up Procedure
To remove the positive and negative connectors from the SUN2000, insert a removal wrench
into the bayonet and press the wrench with an appropriate force, as shown in Figure 5-19.
Before removing the positive and negative connectors, ensure that the DC SWITCH is OFF.
To Next Page
Loading...
