Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-27 Connecting wires to RJ45 connectors
b. Crimp the connectors using a crimping tool.
c. Remove the locking cap from the COM1 waterproof cable connector at the inverter
bottom and remove the plugs from the locking cap.
d. Route the cables through the locking cap and the COM1 connector at the inverter
bottom.
e. Connect the RJ45 connectors to the RS485 IN and RS485 OUT ports in the
SUN2000 maintenance area, as shown in Figure 5-28.
Figure 5-28 Connecting RS485 communications cables
f. Bind the communications cables after connecting them, as shown in Figure 5-29.
To Next Page
Loading...
