5.19.1 2 x 3.5-inch Rear Drive Module
Removing a Rear Drive Module
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 5.8 Chassis Cover.
Step 6 Remove all cables from the rear drive module. For details, see 3 Internal Cabling.
Step 7 Determine the positions of the drives in the rear drive module. See Figure 5-82.
Remove all drives from the rear drive module.
Figure 5-82 Positions of drives
Step 8 Loosen the screws that secure the rear drive assembly. See (1) in Figure 5-83.
The procedure for removing rear drive assembly 1 is the same as that for removing rear
drive assembly 2. The following
gure uses rear drive assembly 1 as an example.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 142
To Next Page
Loading...
