Figure 5-1 Conductive objects to be removed
● Both ends of an ESD wrist strap must be in good contact. One end contacts
your bare skin, and the other is securely inserted into the ESD jack in the
chassis. For details, see 5.2.2 ESD Wrist Strap.
● During parts replacement, keep new server components in ESD bags before
installation, and place removed server components on conductive mats for
temporary storage.
● Do not touch welding points, pins, or exposed circuits.
5.2.2 ESD Wrist Strap
A cabinet or chassis is properly grounded.
Step 1 Put on the ESD wrist strap. See Figure 5-2.
Figure 5-2 Wearing an ESD wrist strap
Step 2 Tighten the ESD wrist strap to ensure that it is in good contact with your bare
skin.
Step 3 Insert the ground terminal of the ESD wrist strap into the ESD jack in a cabinet or
chassis.
----End
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 73
To Next Page
Loading...
