Rear Drive Backplane Cabling for a Server with I/O Module 1
Figure 3-13 Rear drive backplane cabling
Table 3-13 Rear drive backplane cabling
No.
Connectors and Cable Part No.
1 Power cable for connecting the mainboard (J10) to
the drive backplane for I/O module 1 (J1)
04150448-00
1
2 Low-speed signal cable for connecting the front
drive backplane (J32) to the drive backplane for I/O
module 1 (J5)
04052349
3 SAS cable for connecting the front drive backplane
(J31) to the drive backplane for I/O module 1 (J2)
NOTE
This cable is a 1-to-2 cable. One end of the cable is
connected to the front drive backplane, and the other end
with two connectors is connected to the rear drive
backplane. The cable must be routed along the PSU side in
the chassis. The cable length limit prevents cable
connection errors on the rear drive backplane.
04051934-00
1
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 3 Internal Cabling
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 53
To Next Page
Loading...
