1 - 30 Machine Components 704-0212-209 VM Series Maintenance and Safety Manual
Flat Panel Node
The Flat Panel Node (FPN) board communicates console I/O status to the host computer
serially via CANbus. The following devices rely on the FPN to function:
• Program Entry Keyboard.
• Machine Function Keyboard.
• Console Keyboard LEDs.
• Control Panel—Pushbuttons, Lamps, Override dials, E-Stop Status.
• Console Jog Functions (Max console only)—Handwheel, Rapid Jog Feed Dial,
Axis Selector, +/- Jog console keys, Store Position console key, LEDs.
• Floppy Drive—(if equipped) has a dedicated non-CANbus interface that
resides on the FPN. Its SVDC power is sourced from the FPN.
• Remote Jog Unit (FPN provides a CANbus pass-through connection).
Display
The monitor assembly contains a 307.3 mm (12.1 in) LCD TFT module with 800x600
pixel resolution. In addition, a switching power supply and internal A/D board converts
the incoming VGA signal to a digital signal compatible with the LCD module. The monitor
is powered by DC voltage supplied from the Flat Panel Node. Dual-screen consoles have a
brightness control knob under the plastic bezel. Brightness level is fixed on Max console
systems.
USB Drive
A USB (Universal Serial Bus) port is located on the right-hand side of the console. It is
connected to the main CPU via USB active extension cable in the Control Interface
Harness.
Console Jog Unit
Standard Max consoles have a Console Jog Unit. Features include
• Store Position console key
• Manual Pulse Generator (MPG) x1, x10, and x100 rate selections.
• 100 position MPG Handwheel
•Rapid +/- console keys
• Rapid Feed control knob
• Axis selector switch
To Next Page
Loading...
