English - 100
7 Maintenance and
service
7.1 Cleaning
Clean the body, display cover and chassis regu-
larly. The best way to clean the body is with a
damp sponge or cloth. The underside of the body,
wheels and blade disc are best cleaned with a
brush (for example, a washing-up brush). A spray
bottle with water and a small amount of washing-
up liquid can help to remove dried dirt and grass.
Disassemble the body to clean the body, display
cover and chassis more meticulously.
NB! Never use a high pressure washer or even
running water.
The main switch should be in the 0 position. Wear
gloves when cleaning the underside of the body.
It is important to clean off any grass and dirt be-
tween the chassis and the blade disc as well as
between the blade disc and the blades. Disas-
semble the blade disc to enable more thorough
cleaning. Run the blade motor using the Tools -
Test - Motors- Blade motor test function. Listen
for abnormal sounds when the blade motor is run-
ning. Also test with various cutting height settings.
7.2 Winter storage
Before the robotic lawnmower is put away for the
winter, the following should be done:
• Clean the entire mower thoroughly.
• Remove the blade disc and clean around
the blades so that they can be freely
rotated and also around the motor shaft.
• Disassemble the drive wheels and
remove grass and other objects from the
motor shafts. Clean the wheels’ drive
tread. Fit the wheels again.
• Set the main switch in 0 position.
• Fully charge the mower. However, the
mower must not be left in the charging
station during the entire winter storage
period.
IMPORTANT INFORMATION
Charge the battery fully before winter
storage.
7. MAINTENANCE AND SERVICE
To Next Page
Loading...
Need help?
General
