Husqvarna AUTOMOWER 430X Technical Manual

English - 83
6 Troubleshooting
The troubleshooting section consists of 2 main areas:
1. Messages
2. Symptom
Each message and symptom is explained using one or more possible causes of the problem, followed by
one or more solutions.
First go through the basic and installation-related possible causes described in the following sections in this
chapter. Before further troubleshooting and component replacement is carried out, also perform the following
actions:
1. Update the main program and the HMI program to the latest version. Many problems are solved
immediately by the new software. When the robotic lawnmower is connected to Autocheck EXP, the
Assistant noties if a newer software version is available.
2. Reset user settings in the mower by selecting Settings -> Reset user settings, enter the PIN code
and press OK or from Autocheck EXP: Tools -> Reset user settings.
Only if none of the above steps solve the problem, continued troubleshooting should be carried out and any
components replaced.
6. TROUBLESHOOTING

Husqvarna AUTOMOWER 430X Specifications

General

Product Name	Husqvarna AUTOMOWER 430X
Category	Lawn Mower
Cutting Width	24 cm
Cutting Height Min	20 mm
Cutting Height Max	60 mm
Battery Type	Li-ion
Typical Charging Time	50 min
Maximum Incline Within the Working Area	45 %
Cutting System	3 pivoting razor blades
GPS-assisted Navigation	Yes
Lift Sensor	Yes
Tilt Sensor	Yes
Ultrasonic Sensor	No
Battery Voltage	18 V
Weight	13.2 kg
Connectivity	Bluetooth, Cellular
Weather Resistance	Yes
Warranty	2 years