16 Automower from
1. Function
™
In table 5 below the Corridor width required for the
Automower to pass through a passage is presented.
Note that the values are approximate and can always
vary in different installations.
1.10 Search method to find the
charging station
Automower can be set to search for the charging
station in three different ways: Irregular, Follow loop in
and Follow guide wire. With the help of setting options
in the menu Garden - Follow loop - Follow loop in
(shortcut 3-2-2) three search methods can be
combined to optimise the search for the charging
station. The required search method or methods
depend on the shape of the garden.
Search method Irregular is a basic method to search
for the charging station and works well in open areas.
There is no risk of tracks forming. Search method
Follow loop in can however give significantly shorter
search times in more complex installations with
different areas separated by passages or openings.
Automower always starts a search for the charging
station with the irregular search method, under the
condition that none of the delay times for the boundary
wire or guide wire are set to 0
minutes.
Table 5: Greatest possible corridor width for the Automower to pass through a specific passage
Width of
passage (cm)
Version 02.32 2004 Version 02.32 2005
Version 02.32 2006
Version 02.32 2006 LIFT
Corridor width
Boundary wire
Corridor width
Guide wire
Corridor width
Boundary wire
Corridor width
Guide wire
100 0 9 0 6
150 1 15 1 8
200 3 20 3 12
250 4 20 4 16
300 6 20 6 20
350 8 20 8 20
400 9 20 9 20
450 10 20 10 20
500 12 20 12 20
To Next Page
Loading...
Need help?
General
