Automower from 61
4. Autocheck, Service program
™
On the C: drive, where Autocheck was installed, the
following has been installed:
• The Autocheck file which is the executable file.
• Folders, among others, Data, Documents and
Program.
The folder Documents contains pdf-files of among
others the Operator’s Manual for Automower.
The folder Program contains the two files that
Autocheck automatically retrieves when updating
the mower program in an Automower. New files
for the mower program must be saved in this
folder.
4.2 Using Autocheck
1. Connect the service cable (535 13 24-01)
between your computer and Automower:
• Push the connector into the serial port at the
back of the computer and tighten.
• Remove the protective cover on the service
outlet on the underside of the mower, to the left
of the handle.
• Insert the service cable into the service outlet.
The service cable can only be connected in one
way. Look closely at the service outlet on the
mower and make sure you turn the connector the
right way.
IMPORTANT INFORMATION
The entire contents of the folders are used by
Autocheck and must not be deleted.
3012-335
3012-336
To Next Page
Loading...
Need help?
General
