130 Automower from
7. Maintenance and service
™
The charging station, transformer and low voltage
cable should be kept indoors during the winter if
possible. It is then important to remember to protect the
ends of the boundary wire from moisture by placing
them, for example, in a tin with anhydrous grease.
7.3 Service schedule
The table below contains a checklist of points and
actions to be taken when servicing the Automower.
When faults or a need of cleaning are discovered, this
must be rectified before the mower is used again.
Table 16: Service schedule
No. Check/Action For
information,
see:
Replaced parts
1.
Carefully clean the lead-throughs in
the body, primarily the charging
cable (535
13 73-01) to ensure that
the rubber seals fit correctly.
2.
Check the bearings, bearing cage
and hub in the skid plate
(535
07 59-01). Clean between the
skid plate and blade disc
(535
12 63-01) as well as between
the blade disc and the rubber
bellows (535
12 23-01).
page 129
3.
Clean under the body: Inside and
outside of the drive wheels
(535
13 60-02), around the front
wheel axles (535
12 56-01) and the
chassis.
page 129
4.
Check the blades and screws. Operator’s
manual for
Automower
5.
Check the front wheel bearings. page 129
6.
Check the rubber bellows
(535
12 23-01) on the cutting height
adjustment. The rubber bellows
must not be damaged.
page 129
7.
Check the charging strips
(535
13 59-01) and contact strips
(535
13 74-01).
page 105
8.
Check the movability and function
of the collision sensors
(535
12 25-01, 535 09 14-01),
liftsensor
(535 12 25-01,
544
14 15-01) and the front body
suspension (535
14 42-01).
page 37
To Next Page
Loading...
Need help?
General
