Automower from 41
3. Installation
™
3. Installation
3.1 Charging station
The placement of the charging station should be well
planned in order to give the best installation and
function of the Automower from Husqvarna™:
• The charging station should have a central
placement in the working area, so that the
Automower can find it as soon as possible.
A
central placement is of extra importance with
complex installations.
• Automower finds the charging station much
easier when there is a large open area in front of
it. If you use a guide wire and follow it out from
the charging station, it is extremely important
with a large open space, likewise if you have set
the mower for a wide corridor (see
1.9 Corridor
width on page 14).
• The charging station must be positioned on
relatively level ground. The height difference
must not differ more than 5cm between the front
and rear of the charging station.
• The battery is spared if charged in the lowest
possible ambient temperature. Consequently, it is
beneficial if the charging station can be placed
where it is shaded, especially during the warmest
parts of the day.
• The transformer must be placed where it is well
ventilated and is not exposed to direct sunlight.
Under no circumstances may it be enclosed in
any form of small box or plastic bag. The
transformer should be placed under a roof,
preferably indoors.
The supplied low voltage cable is 20 metres
long. The low voltage cable must not be
extended.
It is recommended to use an earth fault-breaker
when connecting the transformer to the wall
socket.
3012-510
3012-554
3012-220
3012-223
To Next Page
Loading...
Need help?
General
