78 Automower from
4. Autocheck, Service program
™
To the right of each value box the same value is shown
in the form of a horizontal column. A green coloured
column signifies an approved value. A yellow colour
signifies an acceptable value. A red colour signifies an
not approved value. For more information about
Searching and Chargings OK see
2.7.1 Operating
history (5-1) on page 28. For more information about
the battery capacity see Battery check on page 20.
Note that threshold values are approximate and they
can very from mower to mower and depending on the
installation.
Operating history: Advanced
To see more details about the mower's function,
highlight the Advanced box. More information and
exact definitions for each function can be found
described under
2.7.1 Operating history (5-1) on page
28.
Key data shows the running time for the mower per
occurred fault, to what degree docking attempts have
been successful, the amount of time it has searched for
the charging station and the amount of time on
average each charge has taken.
Mowing shows when the mower was manufactured,
the amount of hours it has run, mown, searched for the
charging station and how many hours it has been at a
standstill and displayed an error message.
Charging shows the amount of hours the mower has
charged the battery, how many charges have been
successful, how many charges have been interrupted
before the battery has been fully charged, how many
times the mower has attempted to dock, how many
times the collision sensors have tripped when the
mower has been in the N-field and the amount of hours
the mower has been in the charging station and been
switched off by the timer function.
The Battery history is shown in the box at the bottom.
The four most recent battery tests are saved in the
battery history. For more information about the battery
capacity and how a battery check is performed see
1.12.1 Battery check on page 20.
Operating history: Copy all data to new
control box
The Copy all data to new control box function is used
when the control box on an Automower needs to be
replaced. All settings and complete operating history
in the mower can, by using this function, be saved to
a file in the Autocheck folder to then be reloaded to
the mower again when the control box has been
replaced.
3012-570
To Next Page
Loading...
Need help?
General
