Pg 8 S22A/S23A 2001b 2100 v1.0
OPERATOR CONTROL CONSOLE
The operator control console provides the operator with all the controls necessary to operate the saw after
the cutting angle has been set and the stock has been loaded and secured. All of the electrical control functions
of the S-20A Series II or S-23A saw are provided to the operator from the control console which incorporates
the manual control switches, the Sequencer controller, and the Head Up Limit setting knob. The hydraulic
functions of the S-20A Series II / S-23A are controlled from the Hydraulic Feed Control unit. This unit is covered in
detail later in this section, see “Hydraulic Feed Control” on page 25.
The manual control switches allow the operator to raise and lower the Head of the saw, turn the blade on and
off, open and close the vises, move the shuttle, and turn the coolant supply on and off. The control switches are
described by function on the following three pages.
The Sequencer controller provides the
operator with the ability to operate the saw in
automatic mode. Starting on page 11, this
controller is described in detail.
An optional PLC controller can be supplied
for your S Series saw which has fully automatic
capabilities. Starting on page 14, this controller
is described in detail.
E200 PLC interface.
Sequencer Controller
Manual Control Switches for Sequencer
To Next Page
