Pg 19 S22A/S23A 2001b 2100 v1.0
SINGLE PART CYCLE OPERATION
In MAN mode
, the PLC allows the operator to initiate a "Single Part Cycle " to cut one piece at a desired
length. To accomplish this, follow the procedure below.
1) A trim cut should be made before initiating the "Single Part Cycle " operation.
2) Make sure the front vise switch is in the closed position and set the head up limit switch. The AUTO/MAN
indicator light will flash alternately green and red.
3) Make sure the head is set so that the blade is above the material and the head selector switch is in the
HOLD position.
4) The cursor will be flashing at the LENGTH position. Key in the desired value from 0" to 220" and press . If
the value is incorrect, re-enter the value and press again.
5) If the blade is not running, you will be prompted by the word "BLADE" flashing on the display window. Start
the blade and adjust the blade speed as required.
6) When the blade is started, the word “BLADE” will change to the word "CYCLE" flashing on the display window
to begin the cut. Press CYCLE START and the cycle will begin.
7) When the start button is pressed, the shuttle vise will move to the forward home position before executing the
length movement. The head will descend and make the cut.
8) When the cut is completed, the head will rise to the head up limit switch, the blade will stop and the display
window will reset for the next cut.
9) To cut another piece, repeat steps 2 through 6.
NOTES: 1) To "PAUSE" the "SINGLE CUT CYCLE", press the "CYCLE START" button. The "CYCLE
START" button will begin to flash and the screen will indicate a paused condition. All movements
will immediately cease. To continue the cycle, press "CYCLE START" button again.
2) To cut multiple pieces, switch to AUTO MODE and follow the automatic procedures.
BLADE SPEEDBLADE SPEED
BLADE SPEEDBLADE SPEED
BLADE SPEED
LENGTHLENGTH
LENGTHLENGTH
LENGTH
FLASHING
To Next Page
