Pg 40 S22A / S23A mits 2001
PLC 100 PARAMETERS
Parameter DEFINITION
SPEED CONST
WHEEL TRGETS
LTH CLB
(PRESS "ENTER")
ACTUAL LTH
LTH CONST
ACCEL DIST
DECEL DIST
MIN FST DIST
TARGET WINDOW
FVO DWELL
SVO DWELL
CLOSE TIME
FEED RATE
ACTUAL POSITION
HOLD SHT HOME
BRKN PROX
MIN BLD SPEED
SPD PROX DELAY
POWER DWN
TIMER
BLADE CLEAR
TRIM CUT
Blade speed adjustment number. If Actual Blade speed is different than displayed
Blade Speed a new speed factor will need to be calculated. (Providing wheel Trgs is set
correctly): Actual speed / Display = Adjustment factor X Existing speed factor = New
speed factor.
Number of targets per revolution of the idler wheel.
S20A, S23A, H10/14, M16/20 = 1
H18/22, H28/32 = 6.
Length calibration. This is to be used only if calibration is required. Call Hyd
.
Mech
Service department for instruction.
Actual Length Value. Value entered after performing length calibration procedure
(described later in this section). PLC uses this value to calculate it's length encoder
resolution and stroke parameter. Note: If Calibration Procedure is activated and not
completed, or activated and a value not entered for ACT LTH, this value will reset to
00.000 and the PLC will not be able to count/display lengths.
Length constant. Specifies linear distance of shuttle movement in inches per one
pulse of shuttle encoder.
Shuttle acceleration distance. Distance, in inches, the shuttle will travel slowly before
reaching fast speed while starting to move in either direction. (i.e. 1.000).
Shuttle decceleration distance. Distance, in inches, the shuttle will travel slowly
reaching home or target position. (i.e. 1.000)
Minimum fast speed distance. If programmed length is smaller than this parameter
override to slow speed. (Shuttle)
Allowable +/- tolerance from programmed length.
Delay time for the opening of the fixed VISE in seconds.
Delay time for the opening of the shuttle VISE in seconds.
Delay time for the closing of the shuttle or fixed VISE in seconds.
Activates feed rate display. Not active on S20A, S23A and H10 machines.
If this value is set to “YES” displays shuttle vise actual position.
Hold shuttle VISE home and closed during cut.
Allows user to override signal from prox switch in case it is broken. (When set to
“NO” machine will not run with broken proximity sensor. Set to “YES” allows machine to
run).
Minimum blade speed on which blade breakage will be activated.
Delay in monitoring of the blade speed proximity switch during acceleration of the
blade from start to desired speed set by the potentiometer.
If “0” selected, then the machine will shut down after the job is completed. This will
allow the machine to continue running for a specified time after the job (in Manual Mode)
or the cyle (in Auto Mode) has been completed.Range from “0” to “180” minutes.
If set to “YES”; When the AUTO cycle reaches the function of head up, the shuttle will
retract the material from the blade by 1/8" before the head will move up. When the head
reaches the up position the next length of material is shuttled into position.
If “YES” selected the machine will perform a facing cut of the material at the beginning
of an automatic cycle.
---- Continued ----
To Next Page
