HygroMatik Basic-DS - Steambath Operating and Maintenance Parameters

SPA
Page 43
6.2.3 Steambath Operating Parameters
P1 Output Limitation
The steam output can be set to a value between 25% and 100% of
nominal capacity using the steam generation output limitation. The
actual steam output released depends on the control signal.
Limitation of the steam output may be needed for better control.
Example: The steam generation output limitation should be reduced
from P1 = 100% (factory setting) to P1 = 70%.
» press in Operating Mode
» press or until “Commissioning Parameters”
appears in the display
» press
» press
» press
» press
» press
» press or until the “Operation Mode Parameters”
submenu appears in the display
» press
» press again to select P1
» press and then set the first digit to 0; then press
Sprache/Language
ESC
Commissioning-
parameters
ESC
Commissioning-
parameters
Code 0
00
ESC
Commissioning-
parameters
Code 00
0
ESC
Commissioning
parameters
Code 01
0
ESC
Commissioning
parameters
Code 010
ESC
System Test
ESC
Operation Mode
parameters
ESC
Steam Generation
Output Limitation
P1: 100%
ESC
Steam Generation
Output Limitation
P1: 1
00%
ESC