Page 60
7.4.1 T0 Time Clock
(available only with Comfort Plus Control)
If the Timer Mode T0 is programmed to a daily or weekly period
of operation and the external safety chain is closed the steam
generator is released during the programmed periods.
Setting the system time and date:
For commissioning and after changing the battery the current
system time and date has to be set.
By pressing in the time clock menu the system time is dis-
played.
Pressing again allows to change the system time with
or .
Confirm entry with .
Afterwards the current system date can be displayed by pres-
sing .
Changing the system date corresponds to the operating
sequence for the system time.
Setting the Timer Mode
There are three possible settings for the time clock:
• off: time clock is disabled
• weekly: every day the steam generator is released for the
same period of time
• daily: for each weekday the steam generator is released
for a special period of time
The setting:
Within the submenu „Time Clock“ press until „Timer Mode“
appears. Select the „Timer Mode“ submenu by pressing
and choose between the three possible settings with . By
pressing the choosen setting is stored. If a daily or weekly
timer mode is choosen press for putting in the respective
switch-on and switch-off times [hh:mm] (T1 and T2 = weekly
operating period; T3 and T16 daily operating period).
To Next Page
Loading...
