11/7/2008
Hypertherm Plasma systems a-3
SECTION 4 – FIRST AID MEASURES
MSDS
Page 2 of 4
Product
Hypertherm Torch Coolant
CODE
Ingestion
Seek immediate medical attention.
If affected, remove from exposure. Restore breathing. Keep warm and quiet. Seek medical
attention.
Immediately flush eye with cool running water. Remove contact lenses if applicable. Continue
flushing with water for at least 15 minutes. Seek immediate medical attention.
Wash with soap and water. If irritation develops or persists, seek medical attention.
Inhalation
Eye Contact
Skin Contact
Treatment based on judgment of the physician in response to reactions of the patient.
Note to Physician
SECTION 5 – FIRE FIGHTING MEASURES
SECTION 6 – ACCIDENTAL RELEASE MEASURES
SECTION 7 – HANDLING AND STORAGE
Flash Point / Method
None to boiling.
Flammable
limits
Not Established
Extinguishing media
Product is an aqueous solution. Use Carbon Dioxide, Dry Chemical, Foam.
Full protective equipment including self-contained breathing apparatus should
be used. During emergency conditions overexposure to decomposition
products may cause a health hazard. Symptoms may not be immediately
apparent. Get medical attention.
Water base solution.
special fire fighting
procedures
Fire and explosion hazards
Response to
spills
Small spills: Mop up residues and place in a covered waste disposal container.
Large spills: Dike or dam spill. Pump to containers or soak up on inert absorbent. Place in
covered waste dissposal container.
Handling
precautions
Keep container in upright position. Avoid breathing or creating airborne mists. Avoid contact
with skin eyes, and clothing. Avoid inhalation of vapor or mists. DO NOT TAKE
INTERNALLY. Clean up spills immediately.
Storage
precautions
Store in a cool dry place. Keep from freezing. Keep containers tightly closed when not in use.
To Next Page
Loading...
Need help?
General
