What to do if Hypertherm POWERMAX 45 Welding System power ON LED is illuminated and the yellow temperature LED is illuminated?
If the power ON LED is illuminated and the yellow temperature LED is illuminated: * Leave the power supply on to allow the fan to cool the power supply. * If the internal temperature of the power supply approaches ?30° C (-22° F), the temperature LED may illuminate. Move the power supply to a warmer location.
What to do if Hypertherm POWERMAX 45 Welding System power ON LED is not illuminated?
If the ON/OFF power switch is set to ON (I), but the power ON LED is not illuminated: * Verify that the power cord is plugged into the receptacle. * Verify that the power is ON at the main power panel or at the line-disconnect switch box. * Verify that the line voltage is not too low (more than 15% below the rated voltage).
General| Output Current | 45 A |
|---|---|
| Rated Output | 45 A |
| Cutting Thickness | 12 mm |
| Severance Thickness | 19 mm |
| Cutting Method | Plasma |
| Gas Supply | Compressed Air or Nitrogen |
| Torch Lead Length | 7.6 m |
Covers the purpose, installation, assessment of potential problems, and environmental factors for EMC.
Discusses methods to reduce emissions, focusing on mains supply connection.
Details warranty periods, exclusions, legal disclaimers, liability limitations, insurance, transfer rights, and code compliance.
Provides a general description of the Powermax45 and guides users on where to find detailed information.
Details electrical ratings, dimensions, weights, and operating parameters of the power supply unit.
Lists dimensions and performance specifications for T45v and T45m torches.
Explains various safety symbols, certifications, and IEC standards applied to the product.
Guides on unpacking, verifying contents, and handling claims for the power supply unit.
Covers positioning, power requirements, grounding, cord and extension cord recommendations, and generators.
Details preparation, connection, and filtration requirements for the gas supply.
Introduces torch options, explains consumable life factors, and guides on hand torch setup.
Details choosing and installing consumables for the T45v handheld torch.
Covers mounting, consumables, alignment, and connecting interface cables for the T45m machine torch.
Explains the front panel controls, LEDs, and gas pressure indicators for system status.
Details powering on, setting modes, gas pressure, work clamp, and duty cycle for cutting operations.
Provides instructions and tips for using the hand torch, including cutting techniques, piercing, and gouging.
Covers setup, optimizing cut quality, piercing, and troubleshooting machine torch operations.
Outlines regular maintenance tasks, inspection procedures for consumables, and cleaning.
Provides a guide to diagnose and solve common operational problems and fault conditions.
Details steps for replacing covers, work leads, and gas filter elements on the power supply.
Lists and identifies parts for the Powermax45 power supply unit.
Identifies parts and consumables for the T45v handheld torch.
Identifies parts and consumables for the T45m machine torch.
Lists available accessories, replacement parts, and product labels.
To Next Page
