www.hysecurity.com Display Menu D0536 Rev. C 3-13
NOTE: The operator must be turned on and in Run mode. A Run mode display appears on the SDC. If a Run
mode status does not appear on the display, press Reset. If an error, alert, or fault appears on the display, refer to
the “Troubleshooting” section to learn how to clear the display and return to Run mode.
1. Press Open to open the barrier arm.
2. Test the operator.
Cycle the barrier arm a few times by pressing the Close and Open buttons.
NOTE: If additional accessories are to be added, read about “SDC Inputs & Wiring”.
To Next Page
Loading...
Need help?
General
