HySecurity StrongArmPark DCS 14 User Manual

5-8 D0536 Rev. C StrongArmPark DC: Programming & Operations Manual www.hysecurity.com
adjustIng tHe dYnamIC reversIng sensor
StrongArmParkDCusesadynamicreversingsensor.Asolidimmovableobjectblockingthegatewilltripthe
sensorandcausetheoperatortostop,reverseandentersafemode.
Availablesettings(0,1,and2),accessedthroughtheInstallerMenu,
allowyoutoadjustthelevelofsensitivity.Amaximumsensitivityofzero
(0)isthedefaultsetting.
When changing the setting, consider the site design and vehicular gate
trafc.Itisrecommendedthatyouusethemostsensitivesettingwhile
stillallowingforreliablegateoperation.
To adjust the sensitivity, take the following steps:
Atagatestatusdisplay,presstheMENUbuttontwice.TheCLOSETIMER
displayappears.
Simultaneously,presstheOPENandRESETbuttonstoentertheInstaller
Menu.
ReleasethebuttonsandtheLEARNLIMITSdisplayappears.
PressNEXTuntilthedisplay,showninFigure1,appears.Thefactorydefault
settingis0.
UsetheSELECTandNEXTbuttonstonavigateandchangethenumberonthe
display.
PressSELECTagaintoacceptwhatappearsonthedisplay.
ToexittheInstallerMenu,presstheMENUbutton.Thegatestatusappearsin
thedisplayindicatingyouhavereturnedtoRunMode.
NOTE: On the StrongArmParkDC 14, you can also adjust the spring tension,
in combination with the dynamic reversing sensor. A spring that is too tight
can cause a false alert.
Other adjustments involved in the arm reversing include:
• SR(IESSensorLogic)providestwosettings:Halfsecondreversalorfullopen
upontrigger.Thedefaultis½secondreversal.
Formoreinformation,reviewsettingsintheInstallerMenutable.
Ifthedynamicreversingsensoristripped,afaultoccursandSAFEMODEwill
appearonthedisplay.Formoreinformation,refertothe“System Diagnostic
Messages” on page 5-1.
SE 0
IES SENSITIVITY
Figure 1: StrongArmPark DC
Adjusting the dynamic reversing
sensitivity
SE 2
IES SENSITIVITY
OPEN
CLOSE
STOP
MENU
RESET
PREV
NEXT
SELECT
OPEN
CLOSE
STOP
MENU
RESET
PREV
NEXT
SELECT
UC 2
USAGE CLASS
CT 0 (OFF)
CLOSE TIMER
OPEN
CLOSE
STOP
MENU
RESET
PREV
NEXT
SELECT
OPEN
CLOSE
STOP
MENU
RESET
PREV
NEXT
SELECT
HYSECURITY
GATE CLOSED

HySecurity StrongArmPark DCS 14 Specifications

General

Brand	HySecurity
Model	StrongArmPark DCS 14
Category	Gate Opener
Language	English