19
Connecting the power supply (115V)
1. Connect the mains plug to the wall socket.
2.
Use an extension cable that is as short as possible.
3.
Make sure the extension cable is at least 12 awg
and 25 ft. in length*
*refer to extension cord chart on HYTORC.com
Connecting the power supply (230V)
1. Connect the mains plug to the wall socket.
2.
Use an extension cable that is as short as possible.
3.
Make sure the extension cable is at least 12 awg
and 25 ft. in length*
*refer to extension cord chart on HYTORC.com
Connecting the power supply (400V)
1. Connect the mains plug to the wall socket.
2.
If the pump does not start to operate, use a thicker
or shorter extension cable.
3.
Make sure that the direction of rotation is correct.
If the LED indicator on the pump unit lights red,
the direction of rotation is incorrect. Reverse the
polarity of the phase inverter plug.
a) Place a flat-head screwdriver as shown.
b) Turn the insulated plate 180° to reverse the
polarity of the phase inverter plug.
4.2.1
4.2.2
4.2.3
Installation (Cont’d.)