IAI RCP2 - Page 39

27
[Procedure]
1) Remove the slider-cover affixing screws and remove the covers.
After the slider covers have been removed
Caution: Remove the slider covers slowly and gently. If the actuator is installed on the ceiling or oriented
vertically or horizontally on its side, place a plastic bag, etc., underneath the slider covers so as not
to lose the coil springs and spacers in case they drop off.
[1] Standard specification (slider structure)
•
SA5C/SA6C
•
SA7C/SS7C/SS8C/HS8C
[2] Cleanroom specification (roller structure)
•
SA5C/SA6C
•
SA7C/SS7C/SS8C/HS8C
Sheet slider
Sheet slider
Sheet slider
Sheet slider
Plate spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Coil spring
Spacer
Spacer
Roller
Roller
Roller
Roller