IAI RCP2 - Sa5 C, Sa6 C

45
●SA7C
[Items Required for Replacement]
• Replacement motor NRC56-* (with a coupling on the motor shaft; see the photograph below.)
• Allen wrench set • Phillips screwdriver
• Grease (Kyodo Yushi’s Multemp LRL3 or equivalent)
[Procedure]
1) After removing the flat countersunk-head screws (M3 × 8, 2 pcs.) affixing the cable ends on the motor end
cap, remove the pan-head screws (M3 × 105, 4 pcs.) affixing the motor end cap.
• Pan-head screws (M3 × 105, 4 pcs.)
• Flat countersunk-head screws (M3 × 8, 2 pcs.)
Coupling