IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer

Table 13. MCT command definitions (continued)
DEC HEX MCT Default Min Max
195 C3 Scan storage template #2 predefined
location DY0
196 C4 Scan storage template #2 predefined
location X1
197 C5 Scan storage template #2 predefined
location Y1
198 C6 Scan storage template #2 predefined
location DX1
199 C7 Scan storage template #2 predefined
location DY1
200 C8 Scan storage template #2 predefined
location X2
201 C9 Scan storage template #2 predefined
location Y2
202 CA Scan storage template #2 predefined
location DX2
203 CB Scan storage template #2 predefined
location DY2
204 CC Scan storage template #2 predefined
location X3
205 CD Scan storage template #2 predefined
location Y3
206 CE Scan storage template #2 predefined
location DX3
207 CF Scan storage template #2 predefined
location DY3
Extended Microcode tolerance (MCT) information - request (Model TI8
only)
RS-485 Syntax:
X'1D 4E n1 n2'
RS-232 Syntax:
GS N n1 n2 or X'1D; 4E n1 n2'
where:
n1 High order address byte of MCT information that is being requested
n2 Low order address byte of MCT information that is being requested
Purpose:
To enable reading MCT information from EEPROM.
Remarks:
v Only supported on Model TI8 printers.
v MCT data is sent over the serial line in status bytes 9 and 10. See
Table 13 on page 123 for the values of parameter n.
v See “Microcode tolerance (MCT) information - request” on page 123.
August 24, 2004
126 SureMark Printers User’s Guide
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|||
|
|||
|
|
|
|
|
|
|
||
||
|
|
|
|
|
|
|