IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer

Remarks:
v For thermal printing with resident character sets:
Font A = 10-dots (wide) × 20 dots (high) or 1.25 mm × 2.5 mm
Font B = 12-dots (wide) × 24 dots (high) or 1.5 mm × 3.0 mm
Font C = 8 dots (wide) × 16 dots (high) or 1.0 mm × 2.0 mm
Font C, starting with level 38 micro code = 8-dots (wide) x 20 dots (high)
or 1.0 mm x 2.5 mm
v For impact printing:
Font A = dot density of 150 half-dots per inch (resident characters = 1.2
mm × 2.5 mm).
Font B = dot density of 120 half-dots per inch (resident characters = 1.5
mm × 2.5 mm).
Emphasized printing enable and disable, and font A or font B selection
must be at the beginning of a print line to be recognized.
User-defined characters greater than 9 dots high cannot be printed
double high in landscape mode or in the portrait mode of Models TI1 and
TI2.
Double-high and emphasized characters are not valid in landscape
mode.
v Invert cannot be used with overline or underline.
v See “Character fonts” on page 94, “Download user-defined characters”
on page 116, “Set print station” on page 131, and “Select user-defined or
resident character sets” on page 131 for related information.
Example:
Print mode set to font B, emphasized and underlined enabled (n = 89 hex).
Set or cancel double-wide mode
RS-232 Syntax:
ESC W n or X'1B;57;n'
where:
n=00 Cancel double-wide mode
n=01 Set double-wide mode
Default:
n = 00
Set or cancel double-high mode
RS-232 Syntax:
ESC h n or X'1B;68;n'
where:
n=00 Cancel double-high mode
n=01 Set double-high mode
Default:
n = 00
Purpose:
For better print quality with double-high characters in the document station.
August 24, 2004
128 SureMark Printers User’s Guide
|
|