IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer

Enable or disable the beeper (Models TF6 and TM6 only)
This command is supported only for Models TF6 and TM6.
RS-232 Syntax:
ESC BEL n1 n2 or X'1B 07 n1 n2'
where:
n1 Enables or disables beeper.
X'00' Disable beeper.
X'01'–X'FE'
Timed enable beeper.
X'FF' Enable beeper.
n2
Sets the beeper volume and tone.
Bits 0–3
The note. Bit 0 is the LSB.
Bits 4–5
The octave.
Bit 6 Reserved.
Bit 7 Volume. 0 = loud, 1 = soft.
Value (Bits 0–3) Note Value (Bits 0–3) Note Value (Bits 4–5) Octave
0000 – 0 C 1000 – 8 G# 00 – 0 1
0001 – 1 C# 1001 – 9 A 01 – 1 2
0010 – 2 D 1010 – A A# 10 – 2 3
0011 – 3 D# 1011 – B B 11 – 3 4
0100 – 4 E 1100 – C Rest / Silence
0101 – 5 F 1101 – D Reserved
0110 – 6 F# 1110 – E Reserved
0111 – 7 G 1111 – F 1 KHz (normal
beep)
Default:
n = X'00'
Purpose:
To enable or disable the beeper.
Remarks:
v Any value other than X'00' or X'FF' is treated as an amount of time that
the beeper is to be enabled. The time is calculated as n1×0.1 seconds.
v To stop a beep command early, send the Disable Beeper command.
v Timed beeps can be chained together. They can also be downloaded as
canned messages.
v A value of n2=X'2F' is recommended for the most audible tone.
v Set bits 0–3 to 1100 to put a timed silence in a beep sequence.
August 24, 2004
Appendix C. RS-232 programming information 141