IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer User Manual

Note: Spacing in the document-portrait is actually 6.375 lines per inch. Line
spacing dimension is approximate. For the impact printer in portrait
mode, the actual line spacing must be calculated using 51 steps per
inch.
In the impact (document - landscape) station this would be set to 21
steps/line.
This command should be sent after “Set print station parameters” on page
133.
Select color printing
This command is supported only for Models TI3, TI4, TI8, TG3, TG4, TF6, and
TM6.
RS-232 Syntax:
ESC r n or X'1B;72;n;'
where:
n =
00 Cancel color printing
01 Enable full-character color printing
02 Enable half-character color printing
Default:
n = 00
Purpose:
To enable half-character or full-character color printing, or to disable color
printing.
Remarks:
v You can enable and disable full-character color printing within a print line.
This enables you to print one word in a different color.
v This command can be used up to 8 times in a line when full-character
color printing is used.
v Half-character color printing is only supported at the beginning of a print
line.
v If both bit 1 and bit 0 of n are set (n=03), only half-character color
printing will be enabled.
Limitations:
v This command is only valid if the Enable Color Printing command (see
“Select thermal paper” on page 144) is sent first.
v When color paper is enabled, depending on the paper, the printer might
be limited to printing at 15 lps when printing 8 lpi.
Set line spacing using minimum units
RS-232 Syntax:
ESC 3 n or X'1B33;n'
where:
n Specifies line feed steps.
August 24, 2004
134 SureMark Printers User’s Guide
|
|
|
|

IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer Specifications

General

Brand	IBM
Model	4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer
Category	Printer
Language	English