IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal Transfer

Setup commands
Setup commands change character font, inter-character spacing, and the target
print station.
Set print mode
RS-232 Syntax:
ESC ! n or X'1B;21;n'
where:
n Specifies print characteristics, such as user-defined thermal and
impact code pages.
Bit # ↓ Function Bit=0 Bit=1 Thermal Impact
LSB 0 Char/Page 0 See Below See Below yes yes
1 Char/Page 1 See Below See Below yes yes
2 Overline Cancel Set yes no
3 Emphasized Cancel Set yes yes
4 Double-high Cancel Set yes yes
5 Double-wide Cancel Set yes yes
6 Inverted Mode Cancel Set yes no
MSB 7 Underlined Cancel Set yes no
Table 14. Fonts for Models TI3, TI4, TG3, TG4, TI8, TF6, and TM6
Bit 0 Bit 1 User-Defined Thermal
Code Page
User-Defined Impact Code
Page @ Density
Resident
Thermal
Resident
Impact
0 0 Code Page 1 Code Page 1 @ 150 half-dots
per inch
Font A Font A
1 0 Code Page 2 Code Page 1 @ 120 half-dots
per inch
Font B Font B
0 1 Code Page 3 Code Page 2 @ 150 half-dots
per inch
Font C Font A
1 1 Code Page 4 Code Page 2 @ 120 half-dots
per inch
Reserved Font B
Table 15. Fonts for Models TI1 and TI2
Bit 0 Bit 1 User-Defined Thermal
Code Page
User-Defined Impact Code
Page @ Density
Resident
Thermal
Resident
Impact
0 0 Code Page 1 Code Page 1 @ 150 half-dots
per inch
Font A Font A
1 0 Code Page 2 Code Page 1 @ 120 half-dots
per inch
Font B Font B
0 1 Code Page 3 Code Page 2 @ 150 half-dots
per inch
Font A Font A
1 1 Code Page 4 Code Page 2 @ 120 half-dots
per inch
Font B Font B
Default:
n = 00
August 24, 2004
Appendix C. RS-232 programming information 127