IBM eserver pSeries 7311 D10 User Manual

25. If you do not have other adapters to remove, continue with the next step.
OR
If you have other adapters to remove, press the F3 key to return to the PCI
Hot-Plug Manager menu and then return to step 14 on page 150.
26. Press F10 to exit the Hot-Plug Manager.
27. If you have added, removed, or replaced any adapters, run the diag -a command.
If the system responds with a menu or prompt. Follow the instructions to complete
the device configuration.
28. If you have other options to install, refer to “Model D20 FRU Replacement
Procedure List” on page 124. If you do not have other options to install, continue
on to the next step.
29. Replace the service access cover as described in “Service Access Cover
Replacement” on page 128.
30. Push the system drawer back into the operating position as described in “D20
Operating Position” on page 126.
31. Connect the adapter cables.
32. Route the cables through the cable-management arm.
33. Close the rack doors.
Replacing a Hot-Pluggable PCI Adapter
Notes:
1. Use this procedure only when you are replacing an adapter with an identical
adapter. If you are replacing an adapter with an adapter that is not identical to the
adapter removed, go to “Hot-Pluggable PCI Adapter Removal” on page 149 and
“Installing a Hot-Pluggable PCI Adapter” on page 157.
2. Removing a hot-pluggable PCI adapter requires the system administrator to take the
PCI adapter offline before performing any PCI adapter hot-plug procedures. Before
taking an adapter offline, the devices attached to the adapter must be taken offline
as well. This action prevents a service representative or user from causing an
unexpected outage for system users.
For additional information about taking an adapter offline or removing it from the
system configuration, see the AIX
System Management Guide: Operating System
and Devices
.
Documentation for the AIX operating system is available from the IBM Eserver
pSeries Information Center at
http://publib16.boulder.ibm.com/pseries/en_US/infocenter/base. Select AIX
documentation. The
AIX Documentation CD contains the base set of publications
for the operating system, including system-management and end-user
documentation.
This publication is also contained on the AIX Documentation CD. The
documentation is made accessible by loading the documentation CD onto the hard
disk or by mounting the CD in the CD-ROM drive.
Chapter 8. Removal and Replacement Procedures 153

IBM eserver pSeries 7311 D10 Specifications

General

Brand	IBM
Model	eserver pSeries 7311 D10
Category	Server
Language	English