IBM Flex System p260 User Manual

SSSS-135
Explanation: The device failed to configure.
1. Check the BladeCenter management-module event log. If an error was recorded by the system, see POST progress
codes (checkpoints).
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in Replacing the system-board and chassis assembly.
Response:
Failing Item:
v FFC_SSSS
v FFC_252B
v SOFTWARE
SSSS-136
Explanation: The certify operation failed.
1. Check the BladeCenter management-module event log. If an error was recorded by the system, see POST progress
codes (checkpoints).
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in Replacing the system-board and chassis assembly.
Response:
Failing Item:
v FFC_SSSS
SSSS-137
Explanation: Unit attention condition has occurred on the Send Diagnostic command.
1. Check the BladeCenter management-module event log. If an error was recorded by the system, see POST progress
codes (checkpoints).
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in Replacing the system-board and chassis assembly.
Response:
Failing Item:
v FFC_SSSS
v FFC_252B
SSSS-135 • SSSS-137
444 Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide

IBM Flex System p260 Specifications

General

Brand	IBM
Model	Flex System p260
Category	Server
Language	English