IBM Flex System V7000

116 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
There are minimum hardware and software requirements that the system must meet before
you can install or use IFM, which are documented in detail at the following website:
http://publib.boulder.ibm.com/infocenter/flexsys/information/topic/com.ibm.acc.iof
m.doc/dw1li_creating_a_configuration_file_automatically.html
For information regarding how to install, configure, and use IBM Fabric Manager (IFM), visit
this website:
http://publib.boulder.ibm.com/infocenter/flexsys/information/topic/com.ibm.acc.iof
m.doc/dw1li_advanced.html
3.3.3 Logging in to the IBM Flex System Manager Node
The following section gives step-by-step instructions regarding how to log in to the FSM:
1. Open a web browser, and type in the IP address of the FSM. Remember that depending
on the security style, it might be necessary to use https protocol.
2. At the Login panel, enter your User name and Password, as shown in Figure 3-45.
Figure 3-45 shows the FSM login page.
Figure 3-45 IBM Flex System Manager login panel