To Next Page

To Previous Page

Chapter 4. IBM Flex System V7000 Storage

Node initial configuration

This chapter provides the initial configuration steps of the IBM Flex System V7000 Storage

Node. Before the actual installation and the initial configuration, proper planning is important.

We also present an overview of the planning tasks and refer you to the appropriate

documentation as needed to enable you to complete these tasks.

To help you get started and guide you to a successful installation and initial configuration of

your IBM Flex System V7000 Storage Node system, the following topics are described:

򐂰 Planning and Installation requirements

򐂰 Initial setup with IBM Flex System Manager Node and IBM Flex System Chassis

Management Module

򐂰 Setup Wizard for initial configuration

򐂰 System Management

򐂰 Service Assistant

Other manuals for IBM Flex System V7000

Questions and Answers:

Need help?

Do you have a question about the IBM Flex System V7000 and is the answer not in the manual?

General

Form Factor	2U
Model	IBM Flex System V7000
Category	Storage
Power Supply	Dual redundant power supplies
Storage Controller	Dual active-active controllers
RAID Levels	RAID 0, 1, 5, 6, 10
Maximum Drives	240
Expansion Enclosures	Up to 9
Drive Types Supported	SSD, HDD
Host Interface Ports	8 Gbps FC
Scalability	Scalable with expansion enclosures
Operating Temperature	5°C to 40°C
Management Interface	Web-based GUI, CLI, SMI-S