Chapter 4. IBM Flex System V7000 Storage Node initial configuration 155
4.2.1 Using FSM for initial setup
Now that you have installed the IBM Flex System V7000 Storage Node in the chassis with
supported level of code, you can create and configure a clustered system using the FSM. The
following procedure guides you through the necessary steps when using the FSM web user
interface:
1. Open a web browser and point it to the IP address of the FSM and log in. The following
menu panel (Figure 4-1) displays, giving you a number of selections.
Select Launch IBM FSM Explorer from the menu list.
Figure 4-1 Launch IBM FSM Explorer
To Next Page
Loading...
