174 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
You can connect to the Flex System V7000 Storage Node CLI using PuTTY (Figure 4-30).
Figure 4-30 Connect to the CLI using PuTTY
A detailed Command Line Interface setup procedure for the IBM Flex System V7000 Storage
Node is available in Appendix A, “CLI setup and configuration” on page 571. It can also be
found at the following address:
http://pic.dhe.ibm.com/infocenter/storwize/ic/index.jsp?topic=/com.ibm.storwize.v7
000.doc/svc_clicommandscontainer_229g0r.html
4.7 Recording system access information
It is important that anyone who has responsibility for managing the system knows how to
connect to and log on to the system. Pay attention to those times when the normal system
administrators are not available because of vacation or illness. Record the following
information and ensure that authorized people know how to access the system information as
shown in Table 4-1.
Table 4-1 Record log on information
Public Keys: After the first SSH public key is stored, you can add additional SSH public
keys using either the management GUI or the CLI.
Item Value Notes
Management IP address for the GUI and CLI
Management user ID (the default is admin)
Management user ID password (the default is admin)
Control enclosure management IP address
Control enclosure Service IP address: node canister 1
Control enclosure Service IP address: node canister 2
Control enclosure superuser password (default is passw0rd)
To Previous Page
Loading...
Need help?
General
