162 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
For more details on the rest of the setup wizard steps, see 4.3, “IBM Flex System V7000
Storage Node Setup Wizard” on page 162.
4.3 IBM Flex System V7000 Storage Node Setup Wizard
After the initial configuration using the FSM or CMM, we can continue with the setup wizard
for the rest of the configuration of IBM Flex System V7000 Storage Node.
After clicking Finish in Figure 4-11 on page 161, on the next panel, enter the system name
and a new superuser password. At this point, you have the option to use the setup wizard to
configure more settings such as notifications and storage configuration. If you are not ready
to complete more configuration steps now, use the configuration tasks in the management
GUI to complete the configuration at a later time.
When you complete the Initial Setup wizard, return to the FSM or CMM console.
1. After the initial configuration described in 4.2, “Initial setup for IBM Flex System V7000
Storage Node” on page 153 is complete, the IBM Flex System V7000 Storage Node
Welcome window opens (Figure 4-12).
Figure 4-12 IBM Flex System V7000 Storage Node Welcome window
Tip: It is recommended that you upgrade to the most current level of software after
installing the Flex System V7000 Storage Node. The management GUI can be used to
apply software updates. See the IBM Flex System V7000 Storage Node support website
for the latest information about software upgrades.
Tip: During the initial setup of the Flex System V7000, the installation wizard asks for
various information that you should have available during the installation process. If you do
not have this information or choose not to configure some of the items at this time, you can
configure them later through the GUI.
To Next Page
Loading...
Need help?
General
