IBM Flex System V7000 User Manual

158 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
4. Navigate to General Actions and click Launch IBM Flex System V7000 Storage Node
Manage (V7000) as shown in Figure 4-5 to start the Initial Setup wizard. If you do not see
this option, examine the Service IP setting for the storage node. For details, see 4.5.1,
“Changing the Service IP address” on page 171.
Figure 4-5 Launch Storage Manager (V7000)
5. The next window is a welcome window from the IBM Flex System V7000 Storage Node
interface, asking to either create a new system (cluster) or add to an existing system, as
shown in Figure 4-6.
Figure 4-6 IBM Flex System V7000 Storage Node first time setup welcome window

IBM Flex System V7000 Specifications

General

Form Factor	2U
Model	IBM Flex System V7000
Category	Storage
Power Supply	Dual redundant power supplies
Storage Controller	Dual active-active controllers
RAID Levels	RAID 0, 1, 5, 6, 10
Maximum Drives	240
Expansion Enclosures	Up to 9
Drive Types Supported	SSD, HDD
Host Interface Ports	8 Gbps FC
Scalability	Scalable with expansion enclosures
Operating Temperature	5°C to 40°C
Management Interface	Web-based GUI, CLI, SMI-S