4. Secure the enclosure with a screw in the rack mounting screw hole.
5. Reinstall the left and right end caps. (See Figure 14.) The left end cap has
indicator windows that align with the status LEDs (light-emitting diodes) on
the edge of the enclosure.
a. Ensure that the serial number of the end cap matches the serial number on
the rear of the enclosure.
b. Fit the slot on the top of the end cap over the tab on the chassis flange.
c. Rotate the end cap down until it snaps into place.
d. Ensure that the inside surface of the end cap is flush with the chassis.
Figure 14. Inserting the enclosure
Chapter 2. Installing the hardware 25
To Next Page
Loading...
