IBM Storwize V3700 User Manual

7. Check that the host interface adapter is installed squarely in its slot and tighten
the retaining thumbscrew ▌1▐.
8. Reinstall the SFP transceivers that were removed in step 1 on page 30. To install
a transceiver, push it fully into the port and close the release handle.
Installing a 1 Gbps iSCSI 4-port host interface adapter
If you purchased an FC ACHL 1 Gbps iSCSI 4-port host interface adapter that was
not pre-installed for you, you must install it in the node canister.
Before you begin
The 1 Gbps iSCSI 4-port host interface adapter is installed in the node canisters in
the control enclosure. If your control enclosure has two node canisters, you must
install the same options in both canisters. Do not start installation until you have
two of the 1 Gbps iSCSI 4-port host interface adapter options.
Procedure
To install the host interface adapter, complete the following steps.
1. Loosen the retaining thumbscrew ▌1▐ as shown in Figure 20 on page 33.
32 Storwize V3700: Quick Installation Guide

IBM Storwize V3700 Specifications

General

Model	IBM Storwize V3700
Maximum Drives	120
RAID Levels	0, 1, 5, 6, 10
Form Factor	2U
Drive Types	SAS, Nearline SAS, SSD
Host Interface	1 Gb iSCSI, 10 Gb iSCSI, 6 Gb SAS, 8 Gb FC
Cache	4 GB per control enclosure
Number of Host Ports	4 per control enclosure
Cache Memory	4 GB per control enclosure
Power Supply	Dual, hot-swappable
Operating Temperature	10°C to 35°C
Non-operating Temperature	-40°C to 60°C (-40°F to 140°F)
Operating Humidity	20% to 80%
Non-operating Humidity	5% to 95%
Dimensions	8.7 cm x 48.3 cm x 55.6 cm