Notes:
1. Do not have your computer set in an IRQ-shared status when
installing the ThinkPad Modem. If your computer is already in a
sharing status, disable the status before you start the installation.
2. An IRQ can be shared only in Windows 95. You must disable
the status before you start rebooting another operating system.
The default resources are as follows:
I/O 13 -13F
I/O 2F8-2FF
IRQ 3
IRQ 1
DMA 7
Attention
An IRQ can be shared only in Windows 95. If you have a
multipartitioned hard disk drive or have multiple hard disk drives,
and reboot another operating system or install another operating
system, the CMOS status and the hardware settings might not
remain consistent and the devices sharing an IRQ might become
unusable. It is recommended that you use the system in its
default IRQ status, unless you must have the IRQ shared—for
example, because you are using multiple PC Cards and the
docking station simultaneously.
To share an IRQ, do the following:
1
Click on Start, Programs, and ThinkPad Configuration.
2
Click on the Internal Modem icon.
3
Click on the Device Manager button.
4
Double-click on IBM Digital Signal Processor.
5
Double-click on ThinkPad Digital Signal Processor.
|
6
Put a check mark in the Disable in this hardware profile
| check box by clicking on it; then click on OK.
|
7
Double-click on ThinkPad Digital Signal Processor.
84
IBM ThinkPad 600 Online Book
To Next Page
Loading...
Need help?
General
