IBM ThinkPad 600 - Page 92

| 8 Click on the Resources tab.
|
9 Make sure the check mark is removed in the Automatic
| Settings check box.
|
10 Select Basic Configuration 0005.
| Make sure the list is as follows:
| I/O 13 -13F
| I/O 2F8-2FF
| IRQ 3
| DMA 7
|
11 Click on the General tab.
|
12 Remove the check mark in the Disable in this hardware
| profile check box by clicking on it; then click on OK.
13 Restart your computer.
To disable sharing an IRQ, do the following:
1 Click on Start, Programs, ThinkPad, and ThinkPad
Configuration.
2 Click on the Internal Modem icon.
3 Click on the Device manager button.
4 Double-click on IBM Digital Signal Processor.
5 Double-click on ThinkPad Digital Signal Processor.
6 Click on the Resources tab.
7 Click on the Automatic Settings and remove the check mark.
8 Select Basic Configuration 0001.
9 Scroll the Resource Settings list box. Locate and double-click
on the second IRQ 3 resource in the “Resource Type” column.
10 Specify 10 for Value and click on OK.
Chapter 6. Resolving System Resource Conflicts 85