2. Turn the library over and attach the feet 1 to the designated locations on the bottom of the library (Figure 7). Return the library to the upright position.
Figure 7. Attaching the feet
3. Position the deskside cover 2 in the correct orientation over the library chassis and attach the cover to the library with 3 flat-head screws 6 on each side (Figure
8).
Figure 8. Attaching the cover to the library chassis (side screws)
4. Attach the deskside cover with the 2 large pan-head screws 4 on the rear of the library (Figure 9).
Figure 9. Attaching the cover to the library chassis (rear screws)
5. Place the library in the wanted desktop location.
Important: Do not place the library on its side. Do not stack objects on top of the library.
6. Remove the accessor locking screw 1.
Figure 10. Removing the accessor locking screw
7. On the rear panel of the library:
a. Connect the SAS host interface cable.
b. Connect the Ethernet cable.
c. Connect the power cable from the library power supply. Route all cables through the hook-and-loop fastener strap.
d. Power ON the library by toggling the power supply switch to the ON (|) position.
8. Insert the cartridge magazine if previously removed.
To Next Page
Loading...
