IBM TS4300 3555 User Manual

Table 36. Warning events (continued)
Event Code Message Text and Description Details and Solution
4021 Drive was hot-removed while in active
status as data transfer device.
• Put the drive back into the library.
• Follow the “Removing a tape drive” on page
121 procedure to remove the tape drive.
4025 Library test failed due to a cartridge error. Remove the cartridge and inspect it for
damage. Retry operation with another
cartridge.
4028 Library Test failed due to incompatible
cartridge.
Check LTO generation for cartridge and drives.
Remove cartridges that aren’t compatible to
your tape drives.
4029 Library Test failed - Cartridge bar code
indicates incompatibility with drive.
Check if Media bar code label is matching LTO
generation. Replace the label or remove
incompatible media from your system.
4030 Move cartridge operation failed due to
cartridge error.
Remove the cartridge and inspect it for
damage. Retry operation with another
cartridge.
4041 Library Verify failed because the power
supply redundancy test failed.
Ensure that all power supplies are installed
properly (two per module), and that each
power supply is connected to a valid power
source.
4044 One of the Library tests failed because a
source element or destination element
isn’t accessible.
Verify the source and destination elements and
retry the move operation.
4060 Connection to the KMIP server failed.
• Verify the user name and password and all
needed SSL certicates that are needed for
connecting to the KMIP server.
• Verify that the KMIP server is reachable
within the network.
• Verify the IP addresses and host names of
the KMIP servers that are entered into the
wizard.
If this error happens during the connectivity
check, the additional information parameter
includes further error information received
from the Cryptsoft KMIP library. It also includes
the information if the server wasn't able to
ping.
4061 Key isn’t found on KMIP server. Verify that the requested key is available on the
KMIP server. Check the KMIP server logs for
details.
4062 Key creation on KMIP server failed. Check the KMIP server logs for details about
why key creation failed.
4063 KMIP conguration invalid. Use the KMIP conguration wizard to verify the
KMIP conguration.
4064 KMIP feature not licensed. Disable KMIP or install appropriate license for
KMIP feature.
Chapter 5. Troubleshooting 97

IBM TS4300 3555 Specifications

General

Maximum Number of Drives	2
Encryption	Yes
Product Type	Tape Library
Power Supply	Redundant power supplies
Drive Type	LTO-6
Max Capacity (LTO-6)	192 TB (compressed)
Weight	Approximately 85 lbs
Operating Temperature	10°C to 35°C
Interface	Fibre Channel, SAS
Host Interface	Fibre Channel, SAS